This is the current chapter of the Engineering Notebook
It's a Blog -
Read from the bottom up.
Earlier chapters of the notebook can be accessed from the
above menu items.
|
|
Chapter 47
275 -
SETI Database On The Web - 2012-05-14
Now that the Control Panel, and all its modules that make it run are finally
cooking along I can turn my attention back to making the database visible on the
web site. This is the short term goal:
-
Demo - Build a
demo application using the RAD PHP tool set,
-
Grid - Populate
a simple grid control
-
LocalHost -
Have it show up on the local web site.
This is a cook book for that first task (click on the thumbnails):
274 - False Positives - 2012-05-12
The system is
working well - might be too well. I'm getting a lot of hits as I scan
L4 this afternoon. About two an hour. When I go back to falsify
the hits I'm having trouble seeing them in the waterfall and the detection
logic is not re-finding them either.
One just came on.
Lets look at it:
Waterfall clearly
shows two signals. One at 1375,796,590 the other at 1375,796,809 - 220
HZ apart. When I go out of Alarm mode and restart the SpecAna and
Waterfall I cannot find the signals again. I don't think the receiver
or the antenna changed during the switch over.
What could be
causing this?
273 - Operating Better Than Ever - TO DO List 2012-05-11
The changes I made
in the Spectrum Analyzer and the Control Panel have smoothed out the
operation greatly. There are still many to do items:
-
State Change - Moving from Alarm state to
OFF should NOT shut off Spec Ana and Waterfall. Needed for
falsification.
-
Defaults - SpecAna to 32 K, 16mV, 10
Seconds
-
Move on Falsification - After a hit is
falsified the receiver must move ahead by 10 KHz
-
Water - Change where the waterfall starts on
the screen
-
Power Point - Pickup background for
PowerPoint
-
Antenna Com Port - Fix Antenna stumble on
first click
-
Button - Make buttons on Receiver a bit
larger
-
Sky Map Go To - Fix the Sky map drive to
button on the Control Panel